4-4.Connecting Fibre Channel Devices - NEC N8803-034 User Manual

4-4.Connecting Fibre Channel Devices

Install this product in the computer following the steps described on the next step.
Do not handle this product during an electrical storm.
When installing this product in the computer, please read the user's manual of the computer
and unplug the power plug from the electrical outlet. Do not insert or remove the power
plug with wet hands. Doing so can lead to faults or electric shock.
Do not pull on the lead when unplugging the power plug from the electrical outlet. Doing
so can damage the power cord and lead to shorting or electric shock.
Avoid installation in extreme temperature conditions.
Immediately after the server is powered off, its internal components such as hard
disks are very hot. Leave the server until its internal components fully cool down
before installing/removing any component.
Connect firmly.
Please connect the product to the computer firmly. A loose connection can cause
a contact failure and can lead to smoke or fire.
Confirm the power to the computer is off (power lamp off), then unplug the power cord
1.
from the electrical outlet.
Important
Remove the dust cover from Fibre Channel connector of the product.
2.
Important
Confirm that the edge of the Fibre Channel cable and the holes of the connector of this
3.
product are clear.
Mate the cable connector and the connector of this product firmly in the correct
4.
direction.
If the power to the computer is on (power lamp on), shut down the
operating system and then turn off the computer.
Make sure to keep the dust cover carefully.
- 37 -
WARNING
CAUTION