Sabrine And Camila Bed Ends; Installing Side Rails; Verso Ii Side Rail; Britt V And Line Side Rail - Invacare Alegio NG User Manual

3.6.4 Sabrine and Camila bed ends

Mounting
1. Fix the bed end brackets on the bed end panel with
the screws.
2. Insert the bed end brackets into the side tubes of the
mattress support platform.
3. For Sabrine bed ends, fix the bed end on the side tubes
with the finger screws inserted in the second hole. In
some configurations you have to insert the finger screws
in the first hole to fix the foot end.
For Camila bed ends, fix the bed end on the side tubes
with the screws.
Dismounting
1. Unscrew the finger screws or screws, that fix the bed
end on the side tubes.
2. Pull out the bed end panel with the bed end brackets of
the side tubes of the mattress support platform.

3.7 Installing side rails

WARNING!
Risk of personal damage
There is a risk of entrapment or squeezing, while
assembling or disassembling the side rail.
– Pay attention to your fingers.
– Follow instructions carefully.
– After each assembly, check that all fittings are
properly tightened and that the side rail has
the correct function.
Removable 3/4 length side rails
WARNING!
Risk of entrapment
There's a risk of entrapment or suffocation
between mattress support, side rail and bed end.
– When using removable side rails, always make
sure that the distance between the bed end
and the side rail's handle upper edge is less
than 6 cm in the head end and more than 32
cm in the foot end of the bed.

3.7.1 Verso II side rail

Mounting
1561872-F
The mounting of the side rail must be done with the
side rail in locked position.
1. Place both brackets of the side rail on the frame of the
bed, with the locking button A facing towards the foot
end of the bed.
2. Ensure that the bracket near the head end of the bed is
placed encompassing the lifting pole support as shown
in detail B.
3. For beds equipped with bed ends with Sanne style
fitting, it is beforehand necessary to temporarily
disengage the locking pin C from the head bed end
to place the bracket.
a. Pull the locking pin C and rotate 1/4 turn to lock it
in the disengaged position.
b. Position the bracket under the locking pin as
described in step 2.
c. Rotate the locking pin and allow it to engage with
the bed end.
4. After the brackets are positioned correctly on the frame
of the bed, fix the side rail by firmly tightening the
finger screws D.
Dismounting
1. Untighten the finger screws and lift the side rail of the
bed frame.

3.7.2 Britt V and Line side rail

WARNING!
Risk of entrapment / suffocation
The user can get trapped or fall out of the bed if
the side rail is not correctly mounted or damaged.
– Make sure that all gliding shoes are correctly
guided into the bed end guideways.
– Make sure that all side rail bars are above the
locking pin and properly locked.
– Make sure that the straps between the bars are
not damaged or loose.
Setup
11