Advertisement
NOTE: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box.Turning power off
using the fan switch is not sufficient to prevent
electric shock.
1. Remove the 1 of 3 screws from themounting
ring and keep it for future use.Loosen the other
2 screws. (Do not remove)
2. Place the key holes on the switch housing
over the 2 screws previously loosened from the
mounting ring, turn the switch housing until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Figure 12)
3. Make the wire connections: Connect the 9-pin
plug from the fan to the 9-pin plug from the
light kit assembly.
4. Carefully push all wires back into the switch
housing. Attach the light kit assembly to the
mounting plate with 3 screws provided.
5. Mount the glass shades to the light fixture by
unscrewing partway the thumbscrews on the
glass holders, inserting the glass, then gently
tightening the thumbscrews by hand evenly to
the glass. DO NOT OVER TIGHTEN.
6. With the power off, insert the light compact
fluorescent bulbs × 3 (included) into the light
kit sockets. Max. 13 watts.
7. Restore power and your light kit is ready for
operation.
Mounting ring
Mounting plate
Connector plugs
Glass shade
Bulbs
Figure 12
Installing the Light Kit 8.
Fan Without Light Kit
1. Disassemble the switch box from the light kit
by loosing the two plug-in wire connectors,
you can keep the light kit for future use.
(Figure 13)
2. Attach the plastic plug to the switch box.
3. Remove the screws from the mounting ring
under the fan motor, Raise the switch box to the
mounting ring until the holes in switch box and
mounting ring line up. Reinsert the screws to
secure in place.
Screws
Screws
Light kit
assembly
Lock washer
Thumb
Switch housing
screws
Figure 13
Nut
Light kit
Advertisement
