1. The receiver frequency selector is located on
the top of the motor assembly plate as show in
Fig. 14.
2.The transmitter frequency selector is located in
the battery compartment as show in Fig. 15. Each
frequency selector has 4 switches, you may use
any number of possible combinations but you
must set each switch in the transmitter to match
the same switch in the receiver.
Figure 14
9. Operating Your Fan
Code switch
Figure 15
Code switch
Installing the battery:
Load a fresh set of 4 "AAA" 1.5V batteries (not
included) into the battery compartment.
Figure 16