The Firewall's Front Panel; Figure 2-1. Fr114P Front Panel - NETGEAR FR114P Reference Manual

Reference Manual for the Model FR114P, FR114W and FM114P Cable/DSL ProSafe Firewall

The Firewall's Front Panel

The front panel of the NETGEAR ProSafe Firewall contains status LEDs. The FR114P front panel
is shown in Figure 2-1
Figure 2-1. FR114P Front Panel
You can use some of the LEDs to verify connections.
the front panel of the firewall. These LEDs are green when lit, except for the TEST LED, which is
amber.
Table 2-1. LED Descriptions
Label
POWER
TEST
PRINTER
ACT
ALERT
INTERNET
100 (100 Mbps)
LINK/ACT
(Link/Activity)
LOCAL
100 (100 Mbps)
LINK/ACT
(Link/Activity)
WLAN
Setting Up the Hardware
Activity Description
On Power is supplied to the firewall.
On The system is initializing.
Off The system is ready and running.
(These LEDs present only on FR114P and FM114P)
Blinking Data is being transmitted or received by the Printer port.
On (Amber) The connected printer is offline, is out of paper, or has a paper
jam.
On The Internet (WAN) port is operating at 100 Mbps.
Off The Internet (WAN) port is operating at 10 Mbps.
On The Internet port has detected a link with an attached device.
Blinking Data is being transmitted or received by the Internet port.
On The Local port is operating at 100 Mbps.
Off The Local port is operating at 10 Mbps.
On The Local port has detected a link with an attached device.
Blinking Data is being transmitted or received by the Local port.
On The Wireless (WLAN) port is operating (FR114W and FM114P)
Table 2-1 lists and describes each LED on
2-3