NETGEAR FR114P Reference Manual page 82

Reference Manual for the Model FR114P, FR114W and FM114P Cable/DSL ProSafe Firewall
Scroll down to the Drivers section and click on FR114P Print Server driver for Windows.
3.
When asked, select 'Run this program from its current location'.
4.
Follow the steps to install the Print Server driver.
5.
When the installation is finished, make sure the 'Run Print Port Setup now' checkbox is
6.
checked, and click Finish.
The Print Port Setup will then run, and the following screen will be displayed:
7.
The screen should show your firewall and printer.
Click on the Port 1 symbol, and then click the Add button.
8.
Note: Under Windows95, you may receive an error message stating that SETUPAPI.DLL was
not found. In this case, you should either upgrade your Internet Explorer to version 5 or later,
or consult the Print Server Troubleshooting section in this chapter.
A pop-up message will inform you if the port has been created successfully, and then the
9.
Windows Add Printer wizard will start.
Click Next to browse for your printer on the network.
a.
Select the correct Printer Manufacturer and Model, or use the 'Have Disk' option if
b.
appropriate.
7-2 Print Server