Troubleshooting - HOMCOM 800-141 Using Instruction

TIMER SETTING
Timer Delay Time Range: 0.5-19.5 hours.
Default Delay Time: 1 hour.
When the unit is on, set the OFF TIMER so your unit automatically stops once the timer
is up. When the unit is on standby, set the ON TIMER so your unit will automatically
switch on once the timer is up.
How to set the timer
Press the 'TIMER' button- The default time is one hour which is shown on the LCD
display. Press 'SELECT' to choose your desired time. The button 'SELECT' will increase
the time by 30 minutes.
Holding 'SELECT' will change the time quickly. When adjusting the time, the letter 'H' will
flash. Five seconds after choosing your time, 'H' will remain lit, meaning the programme
is complete.
How to cancel the timer
When the timer has been set, press the 'TIMER' button. The digit and 'H' will disappear,
meaning the timer has been cancelled.
Timer delay time
S
'H' stands for Hour,
H
and the duration of the timer

TROUBLESHOOTING

PROBLEM
The Symbol is on
and the arrow flashes.
symbol is on and
'F' flashes.
POSSIBLE CAUSE
Lack of Water.
There is too much ice.
No ice cubes inside.
Fault with the ambient
temperature sensor
The ice making box
cannot reset normally.
9
SOLUTION
Press 'ON/OFF' to stop the ice
maker. Fill with water and press
'ON/OFF' to restart the unit.
Remove the ice cubes.
Remove any objects from the
ice storage, or clean the inside
walls. lf ice is still not being
made, hold 'SELECT' for longer
than five seconds to start the ice
making cycle. Do this for a
maximum10 cycles.
The unit will still work. Contact
the manufacturer, service agent
or an electrical technician to
replace the sensor.
Check with the manufacturer or
a qualified technician.