HOMCOM 800-141 Using Instruction page 9

When ice full indicator is on
6. The ice maker will stop when ice cubes fill the inside. The 'ice full
appear on the LCD display.
How to obtain the ice cubes
7. Put the ice cube container on the drip tray, press the 'ICE' button one time on the
control panel (Button B in above illustration), the
The ice cube pushing spring will start to rotate, and the ice cubes will enter the container
from the tap.
Press 'ICE' again to stop the flow of ice cubes. The
pushing spring will stop rotating.
How to dispense the water
Default time of water flowing:10S.
8. Put the water cup on the drip tray and press the 'WATER' button once on the control
panel (Button C in above illustration). The water will flow from the middle tap, the
symbol will light up, and the '10S' will show in the TIMER delay area on the LCD display.
After 10 seconds, the
If the water dispense time is too short or long, hold the 'WATER' button for longer than
five seconds. '10' will appear in the TIMER delay area. Continue to press 'SELECT' to
change the time, ranging from 7-25 seconds. After five seconds, the digit will disappear
and the new setting will be remembered by the controller. The machine will remember
the new setting when using the dispense again.
How to drain the water inside the unit
9. When cleaning inside of the unit or changing the drinkable water, drain the water
from the reservoir by unplugging the drain cap located at the bottom. If the water has
a plastic soft tube, connect it to the water drain port to drain the water.
10. Change water in the reservoir every 24 hours to maintain good hygiene levels.
When the unit is off, drain the water and dry the reservoir.
symbol will disappear and the water dispense will finish.
Unplug the water drain cap
8
symbol will
symbol will light up on the display.
symbol will disappear and the