Using Your Ice Maker; Troubleshooting - HOMCOM 800-115 Using Instruction

USING YOUR ICE MAKER

1.Open the cover, remove the ice basket and pour water into tank. Keep water
level below the water level mark.
2. Press "Power" button on the control panel to begin the ice making cycle.
3. Select the size of the ice cube by pressing the "Select" button. If the room
temperature is lower than 15℃, it is recommended to select the small or medium
ice sign button in order to avoid ice sticking together.
4. The ice making cycle lasts approx. 6 to 13 minutes, depending on the size of
the ice cube selection and the ambient temperature. In the extreme hot room
temperature, ice-making time maybe vary a lot.
5. While the Icemaker is on, verify water level periodically. If water pump can't
inject water, the ice maker will stop automatically, and the "Add Water" indicator
will be on. Press "Power" button, fill water up to the max. water level mark and
press "Power" button again to turn on the unit again. Allow the refrigerant liquid
inside the compressor at least 3 minutes to settle before
restarting.
6. The ice maker automatically stops working when the ice basket is full and the
"Ice"indicator will be on.
7. Change water in the water reservoir every 24 hours to ensure a reasonable
hygiene level.
If unit isn't in use, drain all water left in the tank.

TROUBLESHOOTING

PROBLEM
"Add Water"
indicator is on.
"Ice" indicator is on.
Ice cubes stick
together.
Ice making cycle is
normal but no ice is
made.
EN
POSSIBLE CAUSE
Lack of Water.
There is too much ice.
The ice cycle is too
long.
Water temperature in
inner tank is too low.
Ambient temperature
or water temperature in
inner tank is too high.
Refrigerant in cooling
system leaks.
Pipe in the cooling
system is blocked.
5
SOLUTION
Stop the ice maker, fill water,
and press "Power" button
again to restart the unit.
Remove ice from ice basket.
Stop the ice maker, and
restart it when the ice blocks
melt. Select the small size
ice cube selection.
Change the water in the
inner Tank. Temperature of
water is better set between
8-32℃.
Please run the ice maker
below 32℃ and pour colder
water into tank.
Verify by a qualified
technician.
Verify by a qualified
technician.