HOMCOM 800-141 Using Instruction page 8

USING THE ICE MAKER
How to start the unit
1. Open the left door and pour drinking water into the reservoir. Keep the water below
the 'MAX' water level mark.
FILL IN WATER
MAX WATER LEVEL
2. Plug your ice maker into the main power outlet, and the "
LCD display.
3. Press the 'ON/OFF' button on the control panel to begin the ice making cycle. After
this, the symbol will remain lit on the LCD display and the
flash. The default size of the ice cubes is large. To change the size, press the
'SELECT' button to switch between large
If the ice cubes are not the right size, change the time of the cycle by pressing the
'SELECT' button. During the cycle, always hold 'ON/OFF' for longer than five seconds,
and '0' will appear in the 'TIMER' delay on the LCD display. This setting is the standard
time for the ice making cycle. Pressing 'SELECT' will change the settings to '1' or '2'.
Pressing 'SELECT' again will revert to '0'. After five seconds, the digit will disappear and
be remembered by the controller. Setting '1' will add one minute to the cycle. Setting '2'
will add extra time. If the unit is reset, it will revert to '0'- The standard time.
4.The ice making cycle lasts 6 to 12 minutes, depending on the selection and the
ambient temperature.
5. While the ice maker is on, check the water level regularly. If the pump cannot pump
out water, the ice maker will stop, the
arrow symbol will flash.
Pour water into the water reservoir. It is recommended to turn off the unit first by
pressing 'ON/OFF', and fill the water up to the MAX level, then press 'ON/OFF' to restart
the unit. Filling the water without pressing any button will result in waiting longer for the
ice cubes. Allow the refrigerant liquid inside the compressor at least three minutes to
settle before restarting.
and small .
symbol will light up on the LCD display, and the
7
"symbol will flash on the
symbol will begin to