Table of Contents
Advertisement
6
WARNING:
such as household oil or motor oil to any part of MEER. Lubrication
is not required under normal circumstances, except during service
performed by a manufacturer trained service technician.
WARNING:
whenever it is submerged in order to prevent the ingress of water into
the system. If MEER has been completely emptied of air underwater, it
is important to return it as soon as possible to a manufacturer trained
service technician for visual inspection and any necessary service
before attempting to refill it.
WARNING:
a water vapor content that does not exceed -53ºC dew point. Excess
water vapor in the air can cause ice to form inside the system and
interfere with the operation of MEER at colder temperatures.
WARNING:
place to prevent over pressurization of MEER. Systems shall be deemed
over pressurized at 5% above working pressure. Should MEER be over
pressurized, a manual purging of the system via the second stage
is necessary to reduce the pressure in the cylinder. It is especially
important to inspect the indicator when transitioning from cold to hot
environments, due to thermal expansion of the gas.
NOTE: When instructed to remove, unscrew or loosen a part, turn the part
counter-clockwise.
When instructed to install, screw, or tighten a part, turn the part clockwise.
NOTE: When instructed to "OPEN" the handwheel, turn the handwheel
counter clockwise. The red indicator ring will not be visible in the
handwheel window, this indicates MEER is in the "ON" position.
When instructed to "CLOSE" the handwheel, turn the handwheel clockwise.
The red indicator ring will be visible in the handwheel window, this indicates
MEER is in the"OFF" position.
NOTE: When instructed to depressurize MEER, close the handwheel and
depress the second stage purge button for 5 seconds and release for 5
seconds. Repeat this procedure until MEER is depressurized.
DO NOT apply any type of petroleum based lubricant,
It is important to ensure that MEER is always pressurized
It is important to fill MEER only with dry, filtered air with
Periodic inspection of dial indicator readings shall take
Advertisement
Table of Contents
