Panasonic PT-43LCX64 Service Manual page 50

3. 1) Disconnect Connector P2904, and remove the Fan 3 Unit by removing the 2 Screw (402).
2) Remove the Top Duct 3 Unit by removing the 4 Screws (421).
CAUTION:
When removing the Screws (421) on the Top Duct 3 Unit, plastic dust may be produced. Therefore, confirm that there is no dust
on the Top Duct 3 Unit. If there is dust, clean the Top Duct 3 Unit with a brush, etc. Otherwise, dust may adhere to the inside of
the screen.
3) Remove the Lamp from the Projection Unit by loosening the Screw.
Screw
for lamp
Replacement Note of Projection Unit (Ref. No. 21):
These parts will be necessary when replacing the Projection Unit (Ref.No. 21). Set aside, and keep and re-use.
• Fan 3 Unit
• Top Duct 3 Unit
Lamp
P2904
Projection Unit
21
Clamper
Fig. D2-3
Fan 3 Unit
402
421
Top Duct 3 Unit
421
GND
Wire
402