Ocean Sonics Buoy Quick Start; Assemble Buoy Configuration; Connect To Ocean Sonics Buoy Wi-Fi; Setup Hydrophone - Ocean Sonics Coastal Acoustic Drifting Buoy User Manual

Ocean Sonics Buoy Quick Start

OSL
Tip:

Assemble Buoy Configuration

1. Ensure the buoy is fully charged and in the OFF position (OFF Position: 0).
2. Attach cables and hydrophones in configuration for deployment (see
3. Turn on Ocean Sonics Buoy (ON Position: 1).

Connect to Ocean Sonics Buoy Wi-Fi

4. Use a PC to connect to the Ocean Sonics Buoy Wi-Fi
(for troubleshooting Wi-Fi see
a. Go to Wi-Fi settings on computer
b. Ensure Wi-Fi is turned on
c. Show available networks
d. Select Buoy Wi-Fi to connect
For buoy Wi-Fi settings see

Setup Hydrophone

5. Open Marco on PC [Ocean Sonics' Software Program found on icListen USB drive].
a. Click Refresh to view the hydrophone(s) connected to the buoy.
b. All units on Marco should be set to DHCP (See
c. Using Marco open the icListen in a Web Browser (double click on serial #).
6. Configure hydrophone for deployment.
a. Set icListen to Synchronise to GPS.
i. Under Special Features ensure Sync In – Falling Edge is selected
For a quick setup install Ocean Sonics' Software Programs
Marco and Lucy on your PC prior to setting up your Ocean Sonics Buoy.
Figure 1. Top Hat of Buoy, Off (0) Position
Appendix
Appendix B.
and Decode Time from PPS is checked.
Ocean Sonics Buoy User Guide
A)
Appendix C
Appendix F).
for Marco Help).
April 2020 P.3