Table of Contents
Advertisement
Ocean Sonics Launch Box Instructions
OSL Tip
Assemble Launch Box Configuration
1. Turn Wi-Fi switch to ON position and wait 2 minutes to allow Wi-Fi to stabilize.
2. Turn remaining switches to ON position.
3. Attach cable(s) and hydrophone(s) in configuration for deployment.
Connect to Launch Box Wi-Fi
4. Use a PC to connect to the Launch Box Wi-Fi
(for troubleshooting Wi-Fi see
a. Go to Wi-Fi settings on computer.
b. Ensure Wi-Fi is turned on.
c. Show available networks.
d. Select Launch_Box_[SerialNumber] to connect.
•
Type in the
For Launch Box Wi-Fi settings see
Setup Hydrophone
5. Open Marco on PC [Ocean Sonics' Software Program found on icListen USB drive].
a. Click Refresh to view hydrophone(s) connected to the Launch Box.
b. All units on Marco should be set to DHCP (See
c. Using Marco open the icListen in a Web Browser (double click on serial #).
6. Configure the hydrophone for deployment.
a. Set the icListen to Synchronise to the GPS.
i. Under Special Features ensure Sync In – Falling Edge is selected
ii.
iii. If the Launch Box is in a location where it can receive a GPS signal,
iv. When it has a GPS sync, the time will indicate it was set by PPS.
For a quick setup install Ocean Sonics' Software Programs
Marco
and
Lucy
on your PC prior to setting up your Launch Box
Appendix
Password: oceansonics
and Decode Time from PPS is checked.
the Home Page should indicate the hydrophone is synchronising or is
Synchronised to PPS (see below).
(This can take up to 5 minutes for a hydrophone to obtain GPS
synchronisation. Ensure the correct date and time are displayed.)
Launch Box User Guide
A).
Appendix B.
Appendix C
for Marco Help).
July 2022
P.4
Advertisement
Table of Contents
