Table of Contents
Advertisement
6.
Now the new modem is visible in Control
Panel, under Phone and Modem > Modems.
Any extra initialization AT command (e.g.,
to set a specific APN name) can be entered
by selecting Properties and filling in
Advanced > Extra initialization commands
text box.
Now the module is ready, and the connection can be configured.
The modem configuration can also be edited in Device Manager, by clicking on the modem name.
B.2 Install and configure a high data rate modem connection on
Windows
This example describes how to install and configure a high data rate packet data connection on a PC
with the Windows 10 operating system, using the TCP/IP stack of the PC, over the native USB
interface of the cellular module connected to the Windows PC by the Cellular Native USB connector
(J105 on the ADP-R6 / ADP-L6).
1. From Control Panel, select Network and
Sharing Center > Set up a new connection
or network".
2.
Click Connect to the Internet and then
Next.
UBX-21035387 - R03
C1-Public
Appendix
EVK-R6 and EVK-L6 - User guide
Page 16 of 27
Advertisement
Table of Contents
