Beep; Set Speed Units - Navman S300 User Manual

NAVMAN

4.1.3 Beep

Set beep ON or beep OFF. When beep is ON, an audible 'beep'
will sound when buttons are pressed.
Access this option
If necessary, press and hold
setup. Press repeatedly until the screen appears as shown
above.
To set button beep status
1) Press to start editing (setting status flashes).
2) Press or to select On or OFF.
3) Press to stop editing.
4) Press to go to the next option, or hold

4.1.4 Set speed units

Set units for speed (km/h or mph).
Access this option
If necessary, press and hold
setup. Press repeatedly until the screen appears as shown
above.
To set speed units
1) Press to start editing (speed units flash).
2) Press or to select km/h or mph.
3) Press to stop editing.
4) Press to go to the next option, or hold
Note: Distance is displayed in units that correspond to user selected
speed units. For example, if you select speed units 'km/h', then
distance is displayed in 'km'.
to turn the power on and enter
km km/h
speed units
to turn the power on and enter
S300
S300 - Setup
status
SYSTEM
SET
to leave setup.
SYSTEM
SET
to leave setup.
1-13