Related Manuals for Navman S300
Summary of Contents for Navman S300
- Page 1 NAVMAN English Deutsch Francaise Italiano Espana Português S300...
- Page 2 NAVMAN S300...
- Page 3 NAVMAN S300 – English S300 USER GUIDE English S300...
- Page 4 Use the memory functions to review data when you are not moving. CAUTION: The Navman S300 GPS Sport.Tool is intended for recreational use only. Do not use this product for obtaining measurements that require professional or industrial precision.
-
Page 5: Table Of Contents
NAVMAN Content 1.0 General information 1.1 Checklist 1.2 Care and maintenance 1.3 Water resistance 1.4 Changing the battery 2.0 Navman S300 interface 2.1 Button functions 2.2 Display screen 3.0 Getting started 3.1 Be outdoors 3.2 Fit the S300 3.3 Startup 3.3.1 Enter setup... -
Page 6: General Information
Do not attempt to disassemble the S300; there are no user serviceable components in this product. The S300 is of robust design. However, care should be taken to protect from shocks or extreme heat. Clean using only a soft cloth with mild soap and warm water. Do not use abrasive cleaning materials or products. -
Page 7: Changing The Battery
NAVMAN 1.4 Changing the battery Always shut down the S300 before changing the battery. Note: All system settings, and the calculated data that was stored at the last controlled shutdown*, are retained when the battery is removed. This information persists indefinitely until updated or reset. -
Page 8: Navman S300 Interface
2.2 Display screen kmmi The illustration above shows the complete display capability of the S300. Only a sub-set of these elements appear at any time during operation. The upper screen section displays the antenna icons, as well as all values and units. The lower screen section displays the mode icons and the setup icon (SYSTEM SET). -
Page 9: Getting Started
3.2 Fit the S300 The S300 is designed to be worn on the left upper arm. The easiest way to fit the unit is to feed the strap through the fastener to create a loose enclosure. Then slide your left arm through the enclosure and tighten the strap after the unit is in a comfortable position. -
Page 10: Enter Setup
3.3.1 Enter setup To enter setup Press and hold to turn the power on and enter setup. When the counter reaches zero, the S300 will enter setup. If you release before the counter reaches zero the S300 will immediately start normal operation. -
Page 11: Setup
Set units (km/h) lets you set the speed units to km/h or mph Set offset (set local time) lets you adjust the S300 to display local time Press and hold to leave setup and start normal operation. S300 S300 - Setup... -
Page 12: Set Time Format
S300 - Setup 4.1.1 Set time format Set 12hr or 24hr time display format. To access this option If necessary, press and hold setup. Press repeatedly until the screen appears as shown above. To set time format 1) Press to start editing (time format option flashes). -
Page 13: Beep
Note: Distance is displayed in units that correspond to user selected speed units. For example, if you select speed units ‘km/h’, then distance is displayed in ‘km’. S300 S300 - Setup status SYSTEM to turn the power on and enter to leave setup. -
Page 14: Set Offset (Set Local Time)
S300 - Setup 4.1.5 Set offset (set local time) This option lets you adjust the S300 to display local time*. You only need to do this once, unless operating the unit in a new time zone. (* By default the S300 displays GPS time. The S300 will perform all functions accurately without adjusting the offset to display your local time.) -
Page 15: Editing Settings (Overview)
(12hr) edit set (31-12) edit beep edit set units (km/h) edit set offset S300 S300 - Setup editing details set 12hr set (12hr) set 24hr set 31-12 set (31-12) set 12-31 beep ON beep beep OFF set units (km/h) -
Page 16: Normal Operation
ON or OFF When Zone is ON you can set minimum and maximum target speeds. Clock shows current time and date GPS time is displayed unless you set local time, see Section 4.1.5. Timer shows session* time (*See glossary.) -
Page 17: Speed Mode
While in Speed (Average) mode • Press and hold to clear all* session data. (*Does not clear odometer.) • Press to go to the next mode. S300 S300 - Normal operation current speed km/h average speed km/h 1-17... -
Page 18: Odometer Mode
While in Odometer mode • Press and hold to clear odometer only. • Press to go to the next mode. Note: The S300 displays distance in units corresponding to speed units (see section 4.1.4). S300 1-18 maximum speed km/h... -
Page 19: Zone Mode
0.5 (hold increase values quickly), or press value by 0.5 (hold to decrease values quickly). 3) Press to stop editing. 4) Press to go to the next mode. S300 S300 - Normal operation status ZONE km/h ZONE repeatedly to decrease 1-19... - Page 20 S300 - Normal operation 5.1.5.2 Zone (Maximum) This option lets you set the maximum target speed. target speed (MAX) Access this mode See section 5.1.5 for access to this mode. To set zone maximum 1) Press to start editing (target speed flashes).
-
Page 21: Clock Mode
(*Does not clear odometer). • Press to go to the next mode. Note: If GPS signals are not yet obtained a ‘no GPS’ alert is displayed. The antenna icon flashes until GPS signals are received. S300 1-21... -
Page 22: Timer Mode
NAVMAN S300 - Normal operation 5.1.7 Timer mode Timer mode lets you monitor session time. session time Access this mode If necessary, press to turn the power on and start normal operation. Press repeatedly until the screen appears as shown above. -
Page 23: Mode Operation (Overview)
� Odometer � edit ZONE Zone OFF Clock � Timer � S300 - Normal operation operating details clear all session data* clear all session data* clear max speed only clear odometer only accept Zone OFF Zone OFF Zone ON accept �... -
Page 24: Restoring Default Settings
After factory default settings have been restored, when the S300 is next turned on you will need to enter setup if you want to display local time or adjust other setting preferences. -
Page 25: Glossary
8.0 Copyright This publication and its contents are proprietary to Navman and are intended solely for the use of its clients to obtain information about the operation of Navman Sport.Tool products, it should not be used or distributed for any other purpose. -
Page 26: Additional Warnings, Disclaimers, And Limitations On Liability
Navman NZ Limited (Navman) neither owns nor maintains the Global Positioning Service (GPS). Navman assumes no responsibility for the quality or continuity of the GPS service. Navman will not accept the return of products where dissatisfaction results from any changes to the GPS service.