Glossary Of Terms - Cantel Medical MEDIVATORS DSD EDGE Service Manual

Shth Sen Err....................... Indicates that the sheet tester measured pressure at the start of a cycle.
Start .................................. Indicates when a cycle was started.
Sth Disabled ...................... Indicates that the sheath (leak) tester was disabled.
Stop ................................... Indicates when a cycle was manually stopped.
Temp = .............................. Indicates the basin temperature at the beginning and end of the disinfect phase.
Water T High ...................... Incoming water temperature exceeding maximum allowed.
Water T Low ....................... Incoming water pump below the minimum around

Glossary of Terms

basin.................................. chamber into which the endoscope is placed for disinfection.
cleaning ............................. physical removal of organic debris from an endoscope.
control panel ...................... operator interface used to program and operate the reprocessor.
custom program ................ disinfection program other than the default program.
cycle .................................. sequence of phases in the disinfection process: detergent flush, basin fill,
..........................................
default program ................. disinfection cycle program supplied with the reprocessor.
disinfection procedure........ pre-programmed series of phases that collectively constitute a specified
..........................................
..........................................
high-level disinfection ........ process defined by the CDC that destroys all vegetative bacteria, viruses, and
..........................................
idle state ............................ standby operating state during which no program cycles or other functions are in progress.
MRC................................... Minimum Recommended Concentration.
phase................................. specific portion of a disinfection cycle.
reservoir ............................ container that holds disinfectant, alcohol, or detergent.
restrictor adapter ............... used to simulate a scope during certain operations. This part is supplied with
..........................................
running state ..................... operating state during which a program is in progress, or some other function is
..........................................
station ............................... part of the system used to disinfect a single endoscope. The station includes the
..........................................
status indicator .................. blinking symbol on the control panel display indicating the current operating state.
status log ........................... stored record of recent disinfection cycles containing usage history, error status,
..........................................
stop state ........................... operating state during which a disinfection protocol is in progress, but the current
..........................................
SSG ................................... Sign Shot Generator
disinfection, rinse, alcohol purge, and air purge.
disinfection protocol function any operation other than a disinfection program,
example: disinfectant dump function.
fungi, but not necessarily all bacterial endospores.
the reprocessor installation kit.
occurring (i.e., any state other than idle or stop).
basin, fluid reservoir, valves, hoses, pump, and compressor.
and processed endoscope serial numbers.
cycle is suspended.
133