Checking The Wiring - Parrot MULTICOMM User Manual

1- Supply the power by turning on the ignition; the Parrot MULTICOMM LED will blink
once.
2- Press the steering wheel command buttons following this sequence: « VOLUME - » ,
« VOLUME + », « SEEK DOWN » Each press will be confirmed by a blinking of the
Parrot MULTICOMM LED.
3- Now press and keep pressed « SEEK UP » button till the Parrot MULTICOMM LED
switch OFF
4- Now press and keep pressed the steering wheel command "HANG UP" phone button;
till the Parrot MULTICOMM LED switch OFF.
5- Now press the steering wheel command "PICK UP" PHONE button; the Parrot
MULTICOMM LED will light ON.
6- Now switch off and on the ignition: the Parrot MULTICOMM LED must be ON.
The procedure is finished and Parrot MULTICOMM has learnt the new protocol.
Note: To reset the unit, with the ignition on, keep the Parrot MULTICOMM button pressed until the LED
blinks
Available functions used with two phone buttons
• Answer an incoming call: Press the «Answer» button.
• End a call: Press the «Hang up» button.
• Refuse a call: Press the «Hang up» button.
• Start the voice recognition feature: Quick press of the «Answer» button.
• Redial the last number: Long press of the «Answer» button.
• Discreet mode : Quick press of the «Answer» button.
• Exit Discreet mode : Quick press of the «Answer» button.
• Increase the volume: During the call, press the «Volume (+)» button.
• Lower the volume: During the call, press the «Volume (-)» button.
Only for Parrot CK3000 EVOLUTION
• Reset the hands-free kit: Repeat the following sequence five times:
press the «Volume (-)» button
and then the «Volume (+)» button
• Enter the menu : Press the following sequence twice: « SEEK UP »
button then the « SEEK DOWN » button. The SEEK
buttons are used to search for radio stations.
• Go forward through the menu: Press the «Volume (+)» button.
• Go backwards through the menu: Press the «Volume (-)» button.
• Select a menu option:
• Cancel a function:

CHeCKiNG tHe WiriNG

Once your Parrot MULTICOMM interface has been correctly fitted, the interface's LED
should light up RED, in which case the interface is ready for use.
If the LED does not light up, check the power wires of your Parrot MULTICOMM interface
• In case of Parrot CK3000 EVOLUTION
- The red and yellow wire should correspond to the Ignition +12V.
• In case of Parrot CK3100 LCD
- The red and yellow wire should correspond to the Permanent +12V.
• The yellow wire of the Parrot MULTICOMM interface should be connected to the yellow
mute wire of the Parrot hands-free kit and to the Mute input on your car stereo (if your car
stereo features a mute input).
Note: It is also important to check the wiring of your hands-free kit. In this case, refer to the user guide
supplied with your kit.
The initialisation procedure must be correctly performed.
If you want to perform it again, please press the «reset» button using a stylus.
1
Quickly press the «Answer» button.
Quickly press the «Hang up» button.