Checking The Wiring; Installing The Audio Connectors - Parrot MKi9200 Quick Start Manual

: On some vehicles, there is no ignition +12V on the vehicle's connectors. You must therefore
Note
connect the orange power supply wire to the fuse box or another ignition power source.

Checking the wiring

x
To perform the installation check, turn the ignition on then off once the Parrot MKi9200 is
installed: the message "Goodbye!" must be displayed.
x
If it is not the case, it is necessary to inverse the positions of the red and orange wires.
Indeed, the red wire of the power cable must be connected to the permanent 12V, the
orange wire to the 12V ignition and the black wire to the ground. This can be done simply by
reversing both fuse holders located on the Parrot wiring.

Installing the audio connectors

Installing the music
cable binding
system
The music cable binding system allows you to adjust the cable length
while reducing its wear.
1. Drill a 20 mm hole in your dashboard (glove compartment or parcel
tray).
2. Insert manually two flexible arms of the binding system.
3. Use a flat screwdriver in order to insert the last two arms.
> You can now connect your music cable to the bluebox
.
7