All manuals and user guides at all-guides.com
•
Checking the
wiring
•
Installing
•
the audio
connectors
•
Installing
•
the remote
control
•
On some vehicles, there is no ignition +12V on the
vehicle's connectors. You must therefore connect
the orange power supply wire to the fuse box or
another ignition power source.
To perform the installation check, turn the ignition
on then off once the Parrot MKi9200 is installed: the
message " Goodbye!" must be displayed.
If it is not the case, it is necessary to inverse the
positions of the red and orange wires. Indeed, the
red wire of the power cable must be connected to the
permanent 12V, the orange wire to the 12V ignition
and the black wire to the ground. This can be done
simply by reversing both fuse holders located on the
Parrot wiring.
Connect the music cable to the electronic box and
place the USB / iPod / Jack connectors into the glove
box, the central console or the parcel tray depending
on the configuration of your dashboard. Make sure
that the cable is not pinched.
Use
the
provided
connectors.
Choose the place for the remote control inside your
vehicle. We would advise you to fit it in the center
of the dashboard or close to the steering wheel.
If you want to place the remote control on the
steering wheel, make sure it is securely attached,
so that it does not move when you are driving. Do
not install the remote control on the outside of the
steering wheel, so that it does not get in the way
when driving.
protection
cap
to
Parrot MKi9200 – User guide
protect
the
8