Attaching The Bowl And Beaters - KitchenAid KEC50C Manual

USING THE STAND MIXER

ATTACHING THE BOWL AND BEATERS

To attach bowl: Turn speed control
1
to "0"� Unplug Stand Mixer�
Spring Latch
Fit bowl supports over locating pins;
press down on back of the bowl until
bowl pin snaps into the spring latch�
3
If not securely snapped into place,
bowl will be unstable and wobble
during use�
Pouring Chute
If using the pouring shield**, from
the front of the Stand Mixer, slide the
pouring shield over the bowl until it
5
is centered� The bottom rim of the
pouring shield should fit within the
bowl�
NOTE: Rotate the pouring shield so the motor head covers the U-shaped gap in the shield�
The pouring chute will be just to the right of the attachment hub as you face the stand mixer�
**Included with select models only� Also available as an optional accessory�
10 | USING THE STAND MIXER
W11330575A.indb 10
Locating Pin
2
Place bowl lift lever in down position�
Slip a beater (flat, wire whip, or
dough hook) onto the beater shaft
4
and press upward as far as possible�
Turn beater to the right, hooking it
over the pin on the beater shaft�
Raise the bowl into mixing position
by rotating the bowl lift lever
6
counterclockwise to the straight up
position� The bowl must always be in
the raised position when mixing�
3/5/2019 10:50:46 AM