Table of Contents
Advertisement
S
ETUP
Connecting Unit to a Controlling Device
Connecting Unit
to a Controlling
Device
NOTE
To connect to the
UX300
NOTE
Contactless
Support
14
UX400 CTLS R
EADER
The device's rear panel has two ports for connection to the UX300 controlling
device:
•
RJ45–8-pin host connector
•
SMA connector
Both connections are necessary for using the contactless unit.
The cables used to connect to the UX300 unit are: CBL159-302-02-X for SMA
connection, and CBL159-301-01-X for data connection.
See
Accessories and Documentation
1
Connect the RJ-45 plug to the rear of the contactless unit.
2
Connect the 8-pin connector to the UX300 unit.
3
Screw in the SMA connector to the rear of the contactless unit.
4
Screw in the SMA connector the UX300 unit.
For further cabling instructions, see
UX400
Figure 3
To disconnect cables, use the same steps described above in reverse. If
exchanging cables, use a VeriFone-approved cable. See
Documentation
for cable ordering information.
This device supports the global contactless program specifications from American
Express, MasterCard, Visa, Discover, ISIS SmartTap, and Google Wallet with
virtually no changes to existing payment hardware or software.
I
G
NSTALLATION
UIDE
for cable ordering information.
Figure 3
RJ-45
SMA
SMA
–
UX300 Cabling Connections
UX300
8-Pin
Accessories and
Advertisement
Table of Contents
