Connecting Ux115 To A Controlling Device; To Connect To A Controlling Device Through A Usb - VeriFone UX115 Installation Manual

S
ETUP

Connecting UX115 to a Controlling Device

Connecting
UX115 to a
Controlling
Device
NOTE
To connect to a
controlling device
through a USB
11
UX115 I
NSTALLATION
Use the following steps to install the UX115 device:
Mounting the UX115 device
Figure 3
1
Align the UX115 device mounting holes to the installation panel holes.
2
Insert four bolts and tighten the nuts using a recommended tightening torque
of 5.0 kgf cm (0.49 Nm or 4.3 lbf in).
The UX115 device can be controlled directly using USB or indirectly using
Ethernet.
This section discusses how to connect the UX115 device to a controlling device.
The UX300 host device installs the USB device driver automatically. The USB
data is encrypted with authentication upon startup.
1
Connect the USB Type B plug to the rear connector of the UX115 device.
G
UIDE