Error Codes - Electrolux T4900CR Operating Manual

Error codes

A fault in the program or in the machine is indi-
1
cated by an error message comprising
an error code and a descriptive text.
The drying program and the error code can
be reset before restarting by holding in the knob
for at least 10 seconds or turning off the power
to the machine.
Code Text
E10 INCORRECT PROGRAMMING
E12 DRYING ERROR WITH
AUTOSTOP PROGRAM
E15 NO VACUUM DETECTED
E27 HEPA FILTER PRESSURE
WARNING
E28 INPUT TEMPERATURE
OSCILLATING
For other error messages or repeated error messages, contact service personnel.
Error codes
Cause/Action
Programming error/incorrect or missing parameter(s).
Maximum allowable Autostop time exceeded
The vacuum switch/pressostat does not shut within
12 seconds after the dryer is started.
High pressure in Hepa filter. Replace filter.
Internal temperature fluctuating.
Warning: the heat has been on/off an unusual amount due
to the intake air temperature having been too high.
Check the air flow through the machine.
Only applies to Clean Room dryers:
Check that the prefilter and filter in the machine are not
clogged. Replace or clean the filter.
1
E10
INCORRECT
PROGRAMMING
13