Mounting Instructions - Sunrise Medical Quickie Nitrum Quick Start Manual

LED light retrofit-kit for Sopur/ Quickie Nitrum
The LED lights are mounted to the caster-links using an
adhesive tape and an allen screw. The Calf-strap is designed as
cable-guide and reinforced to bear the weight of the Controller
Box.
The retrofit-kit for the LED-lights includes:
• Two self-tapping screws
• LED light incl. cable left hand side
• LED light incl. cable right hand side
• Controller.Box incl. Battery
• Reinforced Calf-strap
• 2 Velcro Zip-ties
2

Mounting Instructions:

1. Clean and degrease the bottom side of the caster-links on
both sides of the chair
2. Pull the protective layer off the double adhesive tape on the
bottom of the left-hand-side LED light
3. Insert the self-tapping screw into the bore on the LED-
housing, and align the LED-housing on the caster-link
(without already sticking the adhesive tape on the caster-link)
so that the screw is aligned with the bore on the caster-link.
The LEDs are facing towards the front of the wheelchair.
4. Now press the adhesive tape onto the caster-link to connect
the LED-housing with the caster link. Press and hold for 20
seconds
5. Tighten the self-tapping screw with a max. torque of 2Nm
(Fig. 1)
6. Repeat above for the right-hand-side LED light
7. Mount the calf-strap and adjust length as necessary
8. Route the cables of the LED lights (A) along the frame
towards the calf-strap. Use Velcro-zip-ties (B) to tighten the
cables to the frame underneath the calf-strap (Fig.2)
9. Route the cables through the Velcro-channel (C) on the
backside of the calf-strap towards the middle of the calf
strap (Fig.2)
10. Clip the Controller-Box on the calf-strap, so that it´s located
in the middle of the calf-strap. The USB connector is facing
towards the front of the wheelchair
11. Insert the LED-cable pins into the connectors on each side
of the Controller-Box
12. Cut the rear-cover of the calf-strap to length and Velcro it to
the rear-side of the calf-strap so that it covers the cables
and the Controller-Box
B
LED Light retrofit
Fig. 1
C
A
Fig. 2
Art.nr. 66009910 Rev.A