Advertisement
If you are familiar with both the operation of a 35mm slide
projector and your video display, you may follow an
abbreviated start-up procedure.
Before starting, review the precautions on page 5.
To "Quick Start" the VideoMate 2250, proceed as
follows:
1. Check the voltage setting before powering on. Make
sure that the setting above the power cord is correct
for your voltage. In addition, the fuse behind the
voltage settings needs to be checked.
2. Plug the power cable into a suitable power supply.
3. Connect your TV monitor to the composite video and/
or Y/C (S-Video) output connector on the back panel
of the VideoMate.
4. Set the computer input On/Off switch to OFF. Set the
Auto Focus switch to OFF.
5. Load the slide tray onto the projector
6. Turn on the TV monitor and the VideoMate power
switch.
7. Advance to the first slide.
8. Adjust the iris and focus controls on the rear of the
projector and the TV monitor controls to produce a
suitable image.
Note: A very dark slide may require readjustment of the
iris, but a setting can usually be reached that produces
an acceptable display throughout a range of slides.
9
Advertisement
