Table of Contents
Advertisement
► To use DCTools/Web to enable/disable keypad access
In DCTools/Web go to Communications > Front Panel.
•
Set Access to:
•
Unprotected - keypad access is allowed to view and change parameters, or
•
Read Only - keypad access is allowed to view parameters only, or
•
PIN Protected - keypad access is allowed to view and change parameters if the correct 4-
•
digit number is typed in the Access PIN field. Otherwise, Read Only access is allowed.
► To use the SC200 when access is set to PIN Protected
At the Main Screen press Menu. The Logon screen appears.
•
If the Access PIN is not known then press Skip to use the SC200 with Read Only access.
•
If the Access PIN is known:
•
Use the Left and Right keys to access each digit position. Use the Up and Down keys to
•
change the digits.
When the correct digits are entered, press Logon.
•
Keypad access will return to PIN Protected mode when the display returns to the Main
Screen.
SC100 System Controller
This feature prevents accidental or unauthorized changes to settings from the SC100 keypad.
► To use DCTools/Web to enable/disable keypad access
In DCTools/Web go to Communications.
•
Set UI Access to:
•
Unprotected - keypad access is allowed, or
•
Protected - keypad access is denied (can be temporarily over-ridden, see below).
•
► To temporarily enable keypad access at the SC100 when access is set to Protected
Press Up and Down keys together for 5 seconds.
•
Keypad access is now temporarily enabled. Keypad access control reverts back to Protected
mode after the display goes back to the Summary screen.
Alarm Indicators
Visual indicators
Power on LED (green)
Minor Alarm LED (yellow)
Critical/Major Alarm LED (red)
The system value cannot be displayed because of a failed, disconnected or
???
unconfigured sensor.
Copyright © 2007-2010 Eaton Corporation. All Rights Reserved.
IPN 997-00012-52D
July 2010
System Controller
43
Advertisement
Table of Contents
