Table of Contents
Advertisement
• Preparation of the location and electrical, tap water and
waste water installations at the place of installation is
NOTE
under customer's responsibility. Refer to the nearest
Authorised Service Agent for installation of the product
after those preparations are complete.
• Make sure that the water inlet and drain hoses as well as
the power cable are not folded, pinched or crushed while
pushing the product into its place after installation or
cleaning procedures.
• Manufacturer shall not be held liable for damages that may
arise from procedures carried out by unauthorised persons.
6.2 Removing packaging reinforcement
• Seek someone's help for this procedure.
- Risk of getting injured.
CAUTION!
EN / 16
a) Place the product on a rigid, flat and level surface.
b) Never place the product on a carpet-covered floor.
c) Leaving a gap at the sides of the machine is suggested to reduce
vibration and noise
d) Do not place the product on any platform.
e) Do not place heat sources such as Hobs, Irons, Ovens, etc. on the
washing machine and do not use them on the product.
To remove the packaging reinforcement;
a) Tilt the product backwards.
b) Remove the packaging reinforcement by pulling the
ribbon.
Washing Machine / User's Manual
Advertisement
Table of Contents
