Table of Contents
Advertisement
6. Installation
• While performing the installation of the product, the
calibration mode* always should be run before the first use.
NOTE
• Calibration mode provides accurate sensing of laundry
amount during washing.
• To run the calibration mode, the spin function should be
cancelled by selecting the Drum Cleaning** programme.
• The machine should be empty while the calibration cycle is
running.
• This process takes about 15 minutes. To complete the
calibration mode, you should wait until the programme is
finished.
*Calibration mode may not be available on some models.
**The programme name may vary depending on the model.
For the appropriate programme selection, you can review
the programme descriptions section.
6.1 Appropriate installation location
• Damaged products cause risks for your safety.
- Prior to installation, visually check if the product has any
WARNING!
- If so, do not have it installed.
• Do not place the product on a floor without sufficient
capacity to carry the load.
- Otherwise, the product or the floor may be damaged.
CAUTION!
- Total weight of the washing machine and the dryer -with
• Do not install the product in places where there is the risk
of freezing.
- Otherwise, your product will be damaged and your house
Washing Machine / User's Manual
defects on it.
full load- when they are placed on top of each other is
approx. 180 kilograms.
will be under risk of flood.
EN / 15
Advertisement
Table of Contents
