Combustion (Exhaust) Blower - Intertek 25-CAB80 Manual

• When placing the auger assembly in the unit, always tighten the four auger bearing bolts in a
diagonal (criss-cross) pattern to ensure the bearings and shafts are aligned properly.
Remember to install the auger shelf support, placing the two bottom bolts through the shelf
and the auger bearing.
• NOTE: Follow the same procedure to work on the bottom auger, with the exception that the
pellets do not necessarily have to be removed from the hopper.
• Visit youtube.com/heatredefined for detailed service 'how to' videos.

Combustion (Exhaust) Blower

• Before beginning any component replacement, be certain the unit is unplugged and
thoroughly cooled down.
• Disconnect the pellet vent pipe so that the combustion blower may be accessed.
• Remove the left side access panel, using a 5/16" wrench..
• Remove the back panel of the unit, using a 5/16" wrench.
• Disconnect the power leads to the combustion blower.
• Remove all (5) screws which hold the exhaust blower to the exhaust blower tube. Once the
screws have been removed, the blower can be lifted up and out of the stove.
• Replace the combustion blower gasket each time you remove the blower from the stove
(Part # PU-CBMG). Remove the gasket with a putty knife, and install the new gasket by
applying adhesive to the blower flange and installing the new gasket (instructions and
adhesive are provided with the gasket).
• Reinstallation is the exact opposite of the steps above.
• Visit youtube.com/heatredefined for detailed service 'how to' videos.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
Combustion
(Exhaust) Blower
46