Step 6. Installing The Enclosures - IBM Storwize V7000 Quick Installation Manual

3 Top rail location pin hole
v
7. Insert the rail location pins through the holes in the rack cabinet.
8. Insert a clamping screw into the rack mounting hole between the rail location pins.
9. Tighten the screw to secure the rail to the rack from the back side.
10. Repeat the steps to secure the opposite rail to the rack cabinet.
11. Repeat the procedure for each additional enclosure.

Step 6. Installing the enclosures

CAUTION:
1. To lift and install the enclosure into the rack requires at least two people.
2. Load the rack from the bottom to ensure rack stability. Empty the rack from the top down.
Following your enclosure location plan, install the correct type of enclosure starting from the bottom.
1. On either side of the drive assemblies, remove the enclosure end caps by squeezing the middle of the
cap and pulling it away from the front of the enclosure as shown in Figure 10 on page 12. You can
also use a flat-blade screwdriver to remove the cap.
Chapter 2. Performing the hardware installation
11