Table of Contents
Advertisement
Instructions for Use RAUMEDIC
Step 1:
Call device setup and select
special function OutpO
Step 4:
A control signal of 20 mmHg is
output on both analogue outputs.
Check the displays on the external
system and confirm by pressing
OK.
Manufacturer:
RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany
MPR2 logO
Step 2:
Make the cable connections as
described and then press the OK
key
Step 5:
After the OK confirmation in step
4, enter device setup (figure 4).
Exit screen 4 by pressing the next
key
Page 61 of 99
Step 3:
Carry out a null measurement at
the pressure inputs of the external
system. Press the OK key once
the
null
measurement
successfully completed for both
pressure inputs
Step 6:
pO2 is forwarded via Out1 and
ICP2 via Out2.
zwo-400EN
Rev. 9 2020-09-22
has
Advertisement
Table of Contents
