Cleaning And Care; Troubleshooting - Silvercrest SNAW 1000 D2 Operating Instructions Manual

Cleaning and Care

IMPORTANT
Ensure that no fluids can enter the scale!
This could irreparably damage the appliance.
Do not use abrasive or solvent cleaners .
These could damage the surfaces.
■ For thorough cleaning, remove the weighing platform 1 by turning it anti-
clockwise and lifting it off.
■ Wipe off the scales and weighing platform 1 using a damp cloth and then
wipe both dry with a lint-free cloth.
For stubborn soiling, add a little mild detergent to the cloth. Wipe off any
detergent residue using a cloth moistened with fresh water only.
■ After cleaning, screw the weighing platform 1 back onto the screw on the
scales.

Troubleshooting

In this chapter you will receive important information for malfunction localization
and remedies. Observe the instructions in order to avoid danger and damage.
Observe the following safety information to avoid danger and property damage:
► Repairs to electronic appliances may only be carried out by specialists
who have been trained by the manufacturer. Considerable danger to the
consumer and damage to the appliance can occur as a result of incorrect
repairs.
The following table will help with localizing and remedying minor malfunctions:
Display
The readings on
the display 3
become illegible.
No output on the
display 3.
"E" appears on the
display 3.
SNAW 1000 D2
WARNING
Possible cause
The batteries are very low.
The plastic strip in the bat-
tery compartment 2 has
not been removed.
The batteries are dead.
The permitted maximum
values were exceeded.
Remedy
Replace the batteries.
Remove the plastic strip
from the battery compart-
ment 2.
Replace the batteries.
Observe the maximum
values specified in these
instructions.
GB │ IE │ NI │ 13 ■