Eiki EK-361WST Owner's Manual page 9

About High Altitude mode
● Set [HIGH ALTITUDE] to [ON] in the Setting menu when using the projector at altitudes ap-
proximately 1700 meters or higher.
Using the projector at altitudes approximately 1700 meters or higher without setting to [HIGH
ALTITUDE] can cause the projector to overheat and the protector could shut down. If this
happens, wait a couple minutes and turn on the projector.
● Using the projector at altitudes less than approximately 1700 meters and setting it to [ON] can
cause the light module to overcool, causing the image to flicker. Switch [FAN MODE] to [OFF].
● Using the projector at altitudes approximately 1700 meters or higher can shorten the life of
optical components such as the light module.
Light Module
● A light module containing multiple laser diodes is equipped in the product as the light source.
● These laser diodes are sealed in the light module. No maintenance or service is required for
the performance of the light module.
● End user is not allowed to replace the light module.
● Contact qualified distributor for light module replacement and further information.
Laser safety caution
!
WARNING
CLASS 1 OF IEC 60825-1 THIRD EDITION LASER PRODUCT
● Laser radition- DO NOT stare into beam.
● Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
● This product is classified as Class 1 of IEC 60825-1 3rd edition and RG2 of IEC/EN 62471-5 :
2015 First edition. Obey the laws and regulations of your country in relation to the installation
and management of the device.
● Regarding the installation and management of the equipment, please comply with the relevant
laws and regulations of your country.
● Outline of laser emitted from the built-in light module:
Wavelength: 455 nm
Maximum laser output: : 333mW
● Radiation pattern from the protective housing::
Wavelength: 455 nm
Maximum laser output: : 333mW
● The laser module is equipped in this product. Use of controls or adjustments of procedures
other than those specified herein may result in hazardous radiation exposure.
Safety operation guideline
9