Table of Contents
Advertisement
Use only Nylon/ Stainless Steel (SS) braided hoses (Flexible Hoses) having a minimum
pressure rating of 6 Bar and hoses should be compatible for hot water applications.
Failure to follow this instruction can result in property damage.
Operation
Figure 11
so may result in damage to the Water Heater and injuries to the user. This will also make the
warranty null and void.
Once the Mounting and Plumbing is completed, then only the power supply should be
switched ON.
Do not splash water directly or clean with benzene, pesticides, thinner, alcohol, etc., but use
a soft, dry cloth to clean the Water Heater.
Connecting to Electrical Supply
Figure 12
OFF
ON
CAUTION
1. Open a nearby hot water faucet to permit air to escape.
2.
to the unit.
3.
4. When all water connections are completed, check for leaks and
take corrective action before operating.
CAUTION
Customer should procure a circuit breaker of 32 Amps ratings with
Ensure that wires are connected to circuit breaker and reliable
earthing has been done.
Ensure that the unit should be connected to a single circuit (single
phase supply).
Ensure a separate electric supply cable of 2.5 sq. mm from main
pole breaker is used.
8
Advertisement
Table of Contents
