Table of Contents
Advertisement
Test Installation
Follow these procedures to verify you have correctly
installed the CT32.
TO CHECK FAN (If you connected the G wire):
Touch the fan icon on the HOME screen to turn the fan ON.
Verify that air is blowing from the system.
Touch the fan icon again to return to AUTO.
TO CHECK HEAT
Set the mode to HEAT by pressing the MODE button until
HEAT is displayed.
Touch the temperature display to bring up the MANUAL screen.
+
Touch the
icon and raise the target temp to change target temperature to about 5
allow the system 2 minutes to respond.
Verify that heat is blowing from the system. Return the Target Temperature to a normal setting. Return mode to
OFF by pressing the mode button.
If you have a heat pump, leave in off for 4 minutes before checking COOL.
TO CHECK COOL (do not operate AC if the outside temp is below 65
Set the mode to COOL by pressing the MODE button until COOL is displayed.
-
Touch the
icon and lower cool Target Temperature to change target temperature to about 5
temperature.
Allow the system 5 minutes to respond.
Verify that cool air is blowing from the system. Return mode to OFF by pressing the mode button.
PM
RADIO
1
LINK
TARGET TEMP
o
F)
o
DAY
AUTO
F
COOL
F above room temperature;
F below room
o
11
PG
Advertisement
Table of Contents
