Table of Contents
Advertisement
Congratulations, you have successfully
installed your unit.
Please proceed to the OPERATING Guide to
initialize the CT32.
IMPORTANT: If you have labeled and connected your
wires and followed the correct HVAC setup, and your system
still does not operate, contact technical support.
STATEMENT OF USE: This thermostat can be used with
24VAC heating and cooling systems and also millivolt
heating. It is powered by 4AA batteries, 24VAC (C wire),
or 24VAC adapter. It cannot be used with line voltage
HVAC systems. This thermostat is digital and your
desired heat or cool temperatures can easily be set on
the large touch screen with the +/- icons. In COOL and
heat pump operation, an automatic 4 minute off-time protects the compressor from damage.
This thermostat runs on 4AA batteries. The CT32 can be externally powered with a power source rated from
12V to 24V, AC or DC, at 100ma or greater. If used, connect to the C and RH terminals (no polarity). The 24VAC
"C" wire is the other side of the 24VAC heating transformer and can be found where the other thermostat wires
connect at the wall or at the furnace. Do not use the common or ground side of the line voltage.
12
PG
MENU
button
MODE
button
Advertisement
Table of Contents
