Test Installation - Radio Thermostat CT110 Install Manual

Snap CT110 to Wall plate
Snap the CT110 onto the wall plate. Take care to align with mounting posts at top
and the contact pins at the bottom. With CT110 on the wall plate it is time to turn
the AC power back on. Do this at the breaker you used to switch it off.

Test Installation

Follow these procedures to verify you have correctly installed the CT110.
TO CHECK FAN (If you connected the G wire) - Press the fan button to turn the
fan ON. Verify that air is blowing from the system. Touch the fan icon again to
return to AUTO setting.
TO CHECK HEAT - Set the mode to HEAT by pressing the MODE button until HEAT is displayed.
+
Press the button and raise the target temp to change target temperature to about 5 F above room
o
temperature; allow the system 2 minutes to respond. Verify that heat is blowing from the system. Return the
Target Temperature to a normal setting. Return mode to OFF by pressing the mode button.
If you have a heat pump, leave in off for 4 minutes before checking COOL.
TO CHECK COOL (do not operate AC if the outside temp is below 65 F) - Set the mode to COOL by pressing
o
-
the MODE button until COOL is displayed. Press button and lower cool Target Temperature to change target
temperature to about 5 F below room temperature. Allow the system 5 minutes to respond. Verify that cool air
o
is blowing from the system. Return mode to OFF by pressing the mode button.
11
PG