Table of Contents
Advertisement
• "Fan out" wires as illustrated with CT32 below the wall opening. As
in the example: fan out the wires so that the C wire is above the C
terminal, the W above the W. This allows the CT32 to fit snug to the wall.
• Position the Wires behind the CT32 and up over the terminal area.
• Do not bunch wires behind the CT32. Feed any slack back into the
wall opening.
Connect Your Wires
• Connect labeled wires only to a terminal with the same letter label.
• Insert the wire in the terminal well and tighten the screw securely.
NOTE: If you wish you can mount the CT32 to the wall first, and then
connect the wires.
• The CT32 can be externally powered with a power source rated from
12V to 24V, AC or DC, at 100ma or greater. If used, connect to the C
and RH terminals (no polarity).
from HVAC
System
2.6"
W
from HEAT/COOL system
W
6
PG
Advertisement
Table of Contents
