Check Hvac System; Test Installation - Radio Thermostat CT80 Install Manual

5. If you have AUXILIARY heat, touch the number of stages (default is [NONE] ) use the +/-
buttons to select 1-3 stages. (NOTE: The CT80 controls a maximum of 5 stages total between
pump and AUX.)
6. (If you have AUX) Select the type of auxiliary heat that you have - Electric or Gas-Oil.
NOTE: Most heat pump systems have electric heat strips for auxiliary heat.
7. Fan Control is set by the CT80 (tstat) for heat pumps.
8. Press HOME button to return to the Home
screen.
NOTE: For heat pump system your cooling is
already configured since the heat pump unit
provides both heating and cooling.

Check HVAC system

Test Installation

Follow these procedures to verify you have
correctly installed the CT80.
TO CHECK FAN (If you connected the G wire):
Touch the fan icon and turn the fan ON.
Verify that air is blowing from the system.
Press the fan icon again and return to AUTO.
SAV E
ENER GY
HEA T
COO L
FAN
P o w e r S t a t u
CHEC K
s
FILTE R $ . 0 5 /k W h
Fan
control
Temperature
o
TA RG ET
7 7 o
F
TE M P
HU MI D
2 3
%
H
E A T
+ / - Buttons
Mode
control
11
PG