Table of Contents
Advertisement
Top Features
1. POWER Button (ON / STAND BY) (
Use this button to turn the power on and off when the main power is
supplied and the projector is in standby mode (Power-saving mode
or Idle mode).
NOTE: To turn on or off the projector, press and hold this button for a mini-
mum of two seconds.
2. STATUS Indicator
If this light blinks red rapidly, it indicates that an error has occurred,
the lamp cover is not attached properly or the projector has over-
heated. See the Status Indicator section on page E-45 for more de-
tails.
3. POWER Indicator
When this indicator is green, the projector is on; when this indicator
is orange, it is in standby mode (Power-saving mode or Idle mode).
See the Power Indicator section on page E-45 for more details.
4. SOURCE Button
Use this button to select a video source such as a VCR, DVD player,
PC or Viewer (PC card).
Press and release this button quickly to display the Source List.
Each time this button is pressed for a minimum of ONE second the
input source will change as follows:
Video
S-Video
Component
Video
...
If no input signal is present, the input will be skipped.
5. AUTO ADJUST Button
Use this button to adjust Position-H/V and Pixel Clock/Phase for an
optimal picture. Some signals may not be displayed correctly or take
time to switch between sources.
NOTE: This function may not be available depending upon the input signal.
6. PC CARD Access Indicator
Lights while accessing a PC card.
9
10
4
6
7
8
12
)
Computer
DVI (DIGITAL)
5
11
1
3
7. ENTER Button
Executes your menu selection and activates items selected from the
menu.
8. CANCEL Button
Press this button to exit "Menus". Press this button to return the ad-
justments to the last condition while you are in the adjustment or
setting menu.
9. SELECT
(+) (–) / Volume Buttons
: Use these buttons to select the menu of the item you wish to
adjust.
: Use these buttons to change the level of a selected menu item.
When no menus appear, these buttons work as a volume con-
trol, these buttons can be used to select a slide.
NOTE: When the Viewer is selected, volume control is not available.
10. MENU Button
Displays the menu.
11. LAMP Indicator
If this light blinks red rapidly, it's warning you that the projection lamp
has exceeded 2000 hours (up to 3000 hours in Eco mode) of service.
After this light appears, replace the lamp as soon as possible. (See
page E-43). If this is lit green continually, it indicates that the lamp
mode is set to Eco. See the Lamp Indicator section on page E-45 for
Viewer
more details.
12. 3D REFORM Button
Press this button to enter 3D Reform mode to correct the keystone
(trapezoidal) distortion, and make the image square. This button
toggles between "Keystone" and "Cornerstone".
E-7
2
Advertisement
Table of Contents
