Table of Contents
Advertisement
Top Features
A U
D I O
R G
B
1. Power Button (ON / STAND BY)
Use this button to turn the power on and off when the power is
supplied and the projector is in standby mode.
NOTE: To turn off the projector, press and hold this button for a minimum of
two seconds.
2. Status Indicator
When this is lit red continually, it's warning you that the projection
lamp has exceeded 1000 hours of service. After this light appears,
it is advisable to replace the projection lamp as soon as possible.
(See page E-52). In addition the message "Lamp Running Time is
Over 1000 Hours!!" appears continually until the lamp is replaced.
If this light blinks red rapidly, it indicates that the lamp cover is not
attached properly or the projector is overheated.
See the Status Light Messages on page E-53 for more details.
3. Power Indicator ( )
When this indicator is green, the projector is on; when the indica-
tor is orange, it is in standby mode.
4. Source Button
Use this button to select a video source such as a PC, VCR, DVD
player or PC Card Viewer (CompactFlash card).
Each time this button is pressed, the input source will change as
follows:
→ RGB → Video → S-Video → PC Card Viewer
If no input signal is present, the input will be skipped.
2
3
1
S - V
I D E
O
P C
C O
N T
R O
L
V I D
E O
U S
B
4
5
6
7
P C
C A
R D
5. Auto Adjust Button (RGB only)
Use this button to adjust Position-H/V and Pixel Clock/Phase for
an optimal picture. Some signals may not be displayed correctly or
take time to switch between sources.
6. PC Card Access Indicator
Lights while accessing a CompactFlash memory card.
7. Enter Button
Executes your menu selection and activates items selected from
the menu.
8. Cancel Button
Press this button to exit "Menus". Press this button to return the
adjustments to the last condition while you are in the adjustment
or setting menu.
9. Select (
) / Volume (+) (–) Buttons
:
Use these buttons to select the menu of the item you wish
to adjust.
When no menus appear, these buttons work as a volume
control.
:
Use these buttons to change the level of a selected menu
item.
A press of the
When the menus or the Viewer tool bar is not displayed,
these buttons can be used to select a slide, or to move the
cursor in Folder List or Slide List.
When the pointer is displayed, these
the pointer.
10. Menu Button
Displays the menu.
E–10
10
9
8
button executes the selection.
buttons move
Advertisement
Table of Contents
