Table of Contents
Advertisement
4) Replacing the sprocket
Before fitting a new saw chain, check the condition of the sprocket.
WARNING!
A worn sprocket will damage a new saw chain. Have the sprocket replaced in this
case. The sprocket need to be installed so that it always faces as shown in the figure.
Always fit a new locking ring when replacing the sprocket.
6.2 STORAGE
Clean the tool before storing. Remove any chips and sawdust from the tool after removing the
sprocket cover.
After cleaning the tool, run it under no load to lubricate the saw chain and guide bar.
Cover the guide bar with the scabbard.
Remove oil from the oil tank to empty it and place the chain saw with the tank cap facing upward.
6.3 OPTIONAL ACCESSORIES
WARNING!
These accessories or attachments are recommended for use with your tool
specified in this manual. The use of any other accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment for its stated purpose.
Sprocket
Locking ring
Locking ring
Sprocket
21
Washer
Advertisement
Table of Contents
