Table of Contents
Advertisement
Guide the file as shown in the figure.
-
After sharpening the chain, check the height of the depth gauge using the chain gauge tool
(optional accessory).
-
Remove any projecting material, however small,with a special flat file (optional accessory).
-
Round off the front of the depth gauge again.
-
Wash away dust and particles from saw chain after adjusting the height of depth gauge.
3) Cleaning guide bar
Chips and sawdust will build up in the guide bar groove, clogging it and impairing oil flow. Always
clean out the chips and sawdust when sharpening or replacing the saw chain.
20
Advertisement
Table of Contents
