Table of Contents
Advertisement
-
Ensure that users of this tool have received professional training and know how to set and use
this tool.
-
Do not use the saw to cut firewood
-
Remove all stumbling blocks from the work area.
-
Report or record any defects as soon as possible, including the guards and the saw blade.
-
Install the saw as much as possible on a work stand. Always stay on the side when the saw is
turning.
-
Never use a saw blade that is cracked or deformed.
-
When cutting round wood, use a clamping assembly to prevent slippage of the workpiece.
-
Do not use your hand to remove sawdust, chips or debris near the saw blade.
-
Use only blades recommended by the manufacturer that comply with EN847-1.
-
Do not use high speed steel blades (HSS blades).
-
If the plate inserted on the swivel table is worn or damaged, have it replaced by an authorized
service center
-
Objects such as cloth, strings, should never be left in the working zone. Avoid cutting nails.
Check the workpiece and remove all nails and other foreign objects before starting the machine.
-
Hold the workpiece firmly.
-
Avoid collecting debris or sawdust on the saw before the saw is completely stopped and the
blade guard is in the open position.
-
Do not attempt to release a blocked blade before stopping the machine by pressing the switch
-
Do not attempt to slow down or stop the blade when it is still in the workpiece.
-
Let the machine stop by itself.
-
When you want to pause, turn off the power and wait for the saw to stop completely before
leaving the work area.
-
Periodically check that all fasteners, screws, bolts and nuts are properly tightened.
-
Do not put materials or equipment above the saw to prevent the possibility of an unfortunate fall.
-
Use the saw to cut parts that are insulated from electricity. If you accidentally cut a wire hidden in
the workpiece or cut the power cable of the saw, the metal parts of the saw are covered by the
current, the power must then be switched off immediately and the plug removed from the saw
outlet.
-
Never use the saw near any flammable liquid or gaseous material.
-
Note and remember the direction of rotation of the motor and that of the blade.
-
Do not block the movable blade guard in the open position and make sure it can move freely and
fully cover the blade teeth.
-
Place a saw on a dust collecting bag and ensure it is working properly. As an operator, you need
to know the factors that influence the severity of pollution, such as material type, performance,
and setting of the dust collection or evacuation device. In any case we recommend the use of a
dust mask.
-
Wear gloves when handling saw blades and rough materials.
-
Put the saw blades in a sheath during transport.
-
Select the saw blades according to the type of material to be cut.
-
Use sharp saw blades and observe the maximum speed marked on the blade.
-
Redouble your attention by machining a groove.
-
The miter saw can be transported safely by the main handle, but only when it has been
disconnected from the power outlet and locked in the locked position.
-
Do not use the saw when the guards are not properly assembled, in good condition or well
maintained.
-
Make sure that the arm is securely secured during bevel cutting.
-
Apply the workpiece strongly against the swivel table on which there should be no other pieces
of wood.
-
Ensure that you have received training and / or training and know how to adjust and use this tool.
6
Advertisement
Table of Contents
