Table of Contents
Advertisement
7.8 LIMITING THE CUTTING DEPTH (FIG. 3)
The cutting depth can be infinitely adjusted using the screw (26). To do this loosen the knurled nut on
the screw (26). Turn the screw (26) in or out to set the required cutting depth. Then re-tighten the
knurled nut on the screw (26).
Check the setting by completing a test cut.
7.9 SAWDUST BAG (FIG. 2)
The saw is equipped with a debris bag (21) for sawdust and chips.
Squeeze together the metal ring on the dust bag and attach it to the outlet opening in the motor area.
The debris bag (21) can be emptied by means of a zipper at the bottom.
7.10 CHANGING THE SAW BLADE (FIG. 11 - 14)
Remove the power plug! Important. Wear safety gloves when changing the saw blade. Risk of injury!
Swing up the machine head (5).
Loosen the screw (f) of the flange cover so that it is free to move.
Swing up the saw blade guard (6) to the point where the recess in the saw blade guard (6) is above the
flange bolt (32).
Insert the hexagonal key (c) in the flange bolt (32).
Firmly press the saw shaft lock (4) and slowly rotate the flange bolt (32) in clockwise direction. The saw
shaft lock (4) engages after no more than one rotation.
Now, using a little more force, slacken the flange bolt (32) in the clockwise direction.
Turn the flange screw (32) right out and remove the external flange (33).
Take the blade (7) off the inner flange (37) and pull out downwards.
Carefully clean the flange screw (32), outer flange (33) and inner flange (37).
Fit and fasten the new saw blade (6) in reverse
Important! The cutting angle of the teeth, in other words the direction of rotation of the saw blade (7)
must coincide with the direction of the arrow on the housing.
Move the guide bar into position and tighten the screw (f) again.
Before continuing your work make sure that all safety devices are in good working condition.
Important! Every time that you change the saw blade (7), check to see that it spins freely in the table
insert (11) in both perpendicular and 45° angle settings.
Important! The work to change and align the saw blade (7) must be carried out correctly.
7.11 USING THE LASER/LED (FIG. 10, 15)
To switch on: Move the ON/OFF switch of the laser (35) to the "1" position. A laser line is projected
onto the material you wish to process, providing an exact guide for the cut.
To switch off: Move the ON/OFF switch of the laser (35) to the "0" position. 8.12 Adjusting the laser (Fig.
10) If the laser (34) ceases to indicate the correct cutting line, you can readjust the laser. To do so, open
the screws (36) and set the laser by moving sideways to the laser beam strikes the teeth of the saw
blade (7).
22
Advertisement
Table of Contents
