Table of Contents
Advertisement
ADJUSTING THE EXTENSION TABLE
The extension table gives you the ability to increase the
length of the table for greater ripping capacity.
To use the extension table:
1. Flip the rip fence lock (Fig. 4 - 1) up to unlock the rip
fence (Fig. 4 - 2) and remove it from the table.
2. Unlock the extension table (Fig. 4 - 3) by pushing back
on the extension table lock lever (Fig. 4 - 4).
3. Slide the extension table to the desired width and push
forward on the extension table lock lever to secure it in
place.
NOTE: Use the level scale (Fig. 4 - 5) on the front rail when
a specific width is desired.
4. Reinstall the rip fence and lock in place using the rip
fence lock.
CHANGING THE BLADE DEPTH
NOTE: The blade depth should be set so that the outer
points of the blade are higher than the workpiece by ap-
proximately 1/8 to 1/4 inches. The lowest points (gullets)
should be below the top surface.
1. Tighten the bevel locking lever (Fig. 5 - 1) by turning it
clockwise.
2. Raise the blade by turning the height adjustment wheel
(Fig. 5 - 2) clockwise or lower it by turning the wheel coun-
terclockwise.
CHANGING THE BLADE ANGLE
NOTE: This table saw allows you to make angled cuts from 90° to 45°. A 90° cut has a 0° bevel and a 45° cut has
a 45° bevel.
Adjusting the blade angle:
1. Loosen the bevel locking lever (Fig. 5 - 1) counterclockwise.
2. Move the height adjustment wheel (Fig. 5 - 2) to bevel 0-45° angles and tighten the bevel locking knob clockwise.
12
ASSEMBLY & ADJUSTMENTS
2
5
2
Fig. 4
3
1
4
Fig. 5
1
Advertisement
Table of Contents
