Table of Contents
Advertisement
WARNING! Do not plug in or turn on the tool until it is fully assembled according to the instructions. Read
through and become familiarized with the following procedures of handling and adjusting your tool. Failure to
follow the safety instructions may result in serious personal injury.
WARNING! Before operating the table saw, make sure to equip yourself with a dust mask, ear protection,
and safety glasses for protection from possible injuries. Tie back long hair and do not wear loose clothing or
jewelry. Do not wear gloves while operating the saw.
ON / OFF SWITCH
1. To turn the saw on, press the green "I" button (Fig. 9
- 1). Wait for the blade to reach maximum speed before
starting a cut.
2. To turn the machine off, press the bottom of the power
switch (Fig. 9 - 2). The red "O" button will depress and the
machine will stop running.
RESET BUTTON
This saw comes with an overload reset button. If the motor
overloads, a safety mechanism stops the motor automati-
cally. To prevent motor over-load, reduce load on motor or
check voltage.
1. Allow motor to cool down, then press the reset button
(Fig. 10 - 1) and restart the saw. If the saw does not restart,
wait an additional 5 minutes before restarting.
PUSH STICK
Push sticks are used to push a workpiece through the blade
in any rip cut. When making non-through cuts or ripping
narrow workpieces, always use a push stick, push block,
and / or feather-board so your hands do not come within 3
inches of the saw blade.
The push stick is stored on the front of the table saw (Fig.
11).
14
OPERATION
Fig. 9
1
2
Fig. 10
1
Fig. 11
1
Advertisement
Table of Contents
