Operate Machine - Masalta MT36E Operation Manual

2.5 Operating machine
2.5.1 Adjust handle to suitable operation height
Attention: Don't adjust handle height while operating
2.5.2 Holding the operating handle, Speed adjustment lever to achieve the appropriate
rotating speed.
the motor output belt transmission drive the rotating of blade pan after decelerated
by reducer(Reduction ratio fixed), Speed control function can be achieved through
the effective control of the diameter of the drive pulley of the motor output.
2.5.3 It can be smoothly troweled while the concrete surface to mention relatively
strong after pulping, the operator leaving the lighter footprint indentation on cement
surface. Press down with left hand, and right hand slightly raised allows the
machine to trowel towards to left, Press down with right hand, and left hand slightly
raised allows the machine to trowel towards to right; Pushed forward steadily with
both hands, the machine trowel forward; Pushed forward steadily with both hands,
the machine forward trowel; Pull backwards steadily with both hands, the machine
trowel backwards
2.5.4 Adjustment different angle according to the concrete surface, adjust the knob to
change the angle of the blade.(See graph 1)
2.5.5 Clean the machine after operation.Do not place the machine on a newly completed
concrete surface, to avoid the machine bonded to the concrete.
9